Detail 01
Band D, 584–607 MHz
Fixed UHF range. Other units must sit on different bands or channels to run alongside this one.
Product detailSKU #1316705839082
Galaxy AudioPSE Guitar System, Frequency D 584-607mHz D
1/7
Independent shopping perspective
The Korena take
Entry-level UHF wireless for guitar or bass, band D (584–607 MHz). For players who want to drop the cable on small stages without spending much.
Strong match
Who this is for
- Bar and church stages where one guitarist needs cable-free movement
- Plugging straight into a pedalboard or amp front end
- Feeding a mixer directly via the receiver's XLR out
Consider the trade-offs
When to look elsewhere
- Large multi-channel rigs needing many coordinated wireless channels
- Players wanting a pedalboard-sized receiver — this is a half-rack-style box
- Anyone who needs a specific frequency band other than D
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
XLR and 1/4 inch outputs
XLR goes to a mixer or DI input; the 1/4 inch feeds an amp or pedal chain directly.
Detail 03
XLR output 200 ohms, 1/4 inch 1k ohms
The XLR drives long cable runs to front of house; the 1/4 inch suits short runs into an amp.
Detail 04
Output level −12 dBV XLR, −18 dBV 1/4 inch
Below instrument-level hot. Expect to push the amp or channel gain up a little versus a plain cable.
Detail 05
Image rejection over 90 dB
Helps the receiver ignore strong signals on nearby frequencies, so TV and other transmitters interfere less.
Detail 06
Sensitivity −93 dBm for 30 dB
How weak a signal it can still use cleanly. Determines how far you can walk before dropouts start.
Final check
Know before you order
- 01Receiver runs on an external 12–18V DC supply — needs an outlet at the amp or rack
- 02Pin 2 carries audio, pin 3 does not; balanced-cable behavior differs from a standard mic line
- 03Receiver measures 8.3 x 1.7 x 6.3 inches — plan shelf or rack space, not pedalboard space
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I run two of these at the same time?
Only on different channels or bands. Two units both set to the same frequency in band D will interfere with each other.
02Does it plug straight into my amp?
Yes, through the 1/4 inch output. Output is around −18 dBV there, so you may need slightly more amp gain than with a cable.
03Can I send it to the sound engineer directly?
Yes. The XLR output is impedance balanced at 200 ohms, which drives a long snake run to a mixer input without trouble.
04What frequencies does it use?
Band D, 584 to 607 MHz in the UHF range. Check that this band is clear where you play and doesn't clash with other gear.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- Sensitivity
- -93dBm for 30dB
4 detailsConnections & power
- XLR Output
- Impedance balanced
- Output Impedance
- XLR connector 200 ohms 1/4 inch connector 1kohms
- Audio Output Level
- (+/-30kHz deviation, 1kHz tone) XLR connector (into 600 ohms load) –12dBV 1/4 inch connector (into 3kOhms load) –18dBV
- Power Requirements
- 12-18VDC at 400mA, supplied by external power supply
2 detailsSize & weight
- Weight
- 31
- Dimensions
- 8.3 inch x 1.7 inch x 6.3 inch
4 detailsOther
- Pin2
- Audio
- Pin3
- No Audio
- Image Rejection
- >90dB
- Pin1l
- Ground (cable shield)
