Detail 01
Ferrule only
This is the visible ring the cable passes through. The jack itself, its nut, and washer are separate parts.
Product detailSKU #1273888004320
FenderReplacement Jack Ferrule
Sale
1/2
Independent shopping perspective
The Korena take
A replacement ferrule for a guitar output jack. Buy it when the original is cracked, corroded, or missing — not as an upgrade.
Strong match
Who this is for
- Replacing a broken or lost jack cup on a Fender
- Repair benches stocking common small hardware
- Finishing a partscaster body that shipped without one
Consider the trade-offs
When to look elsewhere
- Guitars using a flat jack plate instead of a ferrule
- Anyone who also needs the jack, nut, and washer
- Non-Fender bodies with a different hole diameter
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Fender replacement part
Dimensioned to Fender body routing. Other builders often drill a different bore, so measure before assuming it seats.
Detail 03
Ferrule, not a jack plate
It seats into a drilled hole in the body. A plate screws flat to the edge; the two are not interchangeable.
Detail 04
Hardware at a stress point
Every cable tug loads this part. A loose ferrule lets the jack behind it turn and eventually breaks the solder joints.
Detail 05
$10.49
Low enough to replace alongside the jack so you are not back inside the body in six months.
Final check
Know before you order
- 01Output jack, nut, and washer are not included
- 02Compare hole diameter against the old ferrule before ordering
- 03A pulled-out jack often means a damaged body hole, not just a bad ferrule
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this come with the output jack?
No. It is the ferrule alone. You will need the jack, and usually its nut and washer, separately.
02Is a ferrule the same as a jack plate?
No. A plate screws flat onto the body edge. A ferrule seats into a drilled hole in the body. Swapping between them means new drilling.
03Will it fit a Telecaster?
Teles with a cup-style jack recessed into the side of the body use a ferrule. Teles with a flat plate on the edge need a plate instead.
04How do I install it?
Unsolder or free the jack, remove the old ferrule, seat the new one in the hole, refit the jack and tighten the nut against it.
