Detail 01
Batter and snare side in one pack
Both surfaces get replaced at once, so response resets evenly instead of a new top fighting an old bottom.

Independent shopping perspective
A two-head snare replacement pack — batter plus snare side — with a pair of 5A nylon-tip sticks. For drummers redoing a snare in one go.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Both surfaces get replaced at once, so response resets evenly instead of a new top fighting an old bottom.
Detail 02
A ring near the perimeter tames overtone ring while leaving the center open, so you can skip tape or gel.
Detail 03
Extra material at the center where sticks land. Attack stays focused and the strike zone wears slower.
Detail 04
Thin bottom head. It sets wire sensitivity and crispness far more than it sets the drum's pitch.
Detail 05
Standard mid-weight stick. Nylon tips give a brighter, more defined ping on ride and hats.
Detail 06
The tip resists the chipping wood gets from hi-hat edges, but it can pop off after heavy use.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
The reverse dot head is the batter and goes on top. The thin snare side head goes on the bottom, under the wires.
Yes. You need one to remove the old heads and tension the new ones. It isn't part of this pack.
Nylon reads brighter and more articulate, especially on ride bell and hats. Wood sounds warmer and blends more.
Yes, the wires stay. Loosen them off the drum while you change the bottom head, then reseat and retension.