Detail 01
Two-way split
One microphone reaches two consoles at once, so the monitor and recording engineers stop fighting over the same input.
Product detailSKU #1273887987184
ArtSplitCom Pro 2 Way Mic Splitter / Combiner
Sale
1/3
Independent shopping perspective
The Korena take
A two-way microphone splitter that also runs backwards as a combiner. For anyone who needs one mic feeding two consoles, or two sources sharing one input.
Strong match
Who this is for
- Sending one mic to front-of-house and a recording rig
- Stages where a second console needs the same source
- Merging two mic-level sources into a single board input
Consider the trade-offs
When to look elsewhere
- Multi-channel stage splits; you need one unit per microphone
- Line-level or speaker-level signals — this is a mic-level box
- Anyone wanting gain or tone shaping; it only routes signal
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Combiner mode
Run it the other direction and two mic sources share one channel, useful when the board is out of inputs.
Detail 03
Splitter box rather than a Y-cable
A hard-wired Y cable makes the two destinations load each other and drops level. A dedicated splitter is built for the job.
Detail 04
Sits at mic level
It goes between microphone and preamp, before any gain, so both destinations get the same untouched signal.
Detail 05
One mic path per unit
A four-microphone stage means four boxes. Cheap per channel, but it adds up on a full band.
Final check
Know before you order
- 01Cables are not included; budget XLR runs for both destinations
- 02One unit per microphone — count your channels before ordering
- 03Confirm phantom power reaches your mic through it before relying on a condenser
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I split one mic to two mixers with this?
Yes, that's the main job. One microphone feeds two destinations at once, so a house console and a recording setup can share the same source.
02Does it work as a combiner too?
Yes, in reverse: two mic-level sources into one output. That frees an input when your board is full.
03How many channels does it handle?
One microphone path, split two ways. Multi-mic setups need one unit per mic.
04Will it work with condenser mics?
Check that phantom power from your preamp still reaches the microphone through the unit. Dynamic mics need no power and are the simpler path.
