Detail 01
Dual channel
Two fully independent EQs in one chassis. Run them as a stereo pair, or as two unrelated mono sends.
Product detailSKU #1273887997589
dbx1215 Dual 15-Band Graphic Equalizer
Independent shopping perspective
The Korena take
Two independent channels of 15-band graphic EQ in one box. For tuning a stereo PA or a pair of monitor mixes.
Strong match
Who this is for
- Ringing out two monitor mixes with separate cuts on each
- Stereo front-of-house tone shaping ahead of the amplifiers
- Fixed installs where the curve gets set once and left
Consider the trade-offs
When to look elsewhere
- Chasing narrow feedback frequencies — 15 bands is coarse
- Small setups already covered by the mixer's channel EQ
- Anyone wanting recallable presets; the faders are the only memory
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
15 bands per channel
Works out to roughly two-thirds-octave spacing — broad enough for tone shaping, too wide for surgical notches.
Detail 03
Graphic fader layout
Every band's setting is readable at a glance, which matters when you're adjusting by ear during soundcheck.
Detail 04
Line-level processor
It belongs between console output and amp or crossover, or in a console insert — not between a guitar and an amp.
Final check
Know before you order
- 01Confirm rack space and mounting hardware before ordering
- 02Budget two more cable pairs — an in and out per channel
- 03Cut to fix feedback; boosting into a ringing frequency makes it worse
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use it in stereo?
Yes. Use one channel per side and match the fader positions. The two channels are independent, so you can also run them as separate mono paths.
02Is 15 bands enough to ring out monitors?
It handles broad problem areas well. Narrow feedback frequencies often fall between bands, so you end up cutting wider than you'd ideally like.
03Where does it go in the signal chain?
Between the console output and the amplifier or crossover, or in a console insert. It expects line level on both input and output.
04Can I run a guitar through it?
Not directly. It's a line-level device, so an instrument pickup feeding it straight in will be far too quiet and lose high end.
