Detail 01
Long rod
Yamaha lists short and long rods for these stands. Measure your old one before ordering.
Product detailSKU #1315669890232
YamahaPERL Long Hi-Hat Rod for HS-1200/1200T/1200D
Independent shopping perspective
The Korena take
Replacement long hi-hat pull rod for Yamaha HS-1200 series stands. Buy it if your rod is bent, stripped, or missing.
Strong match
Who this is for
- Repairing an HS-1200, 1200T, or 1200D that won't seat cleanly
- Keeping a spare in the hardware case for gigs
- Replacing a rod bent in transit or a fall
Consider the trade-offs
When to look elsewhere
- Other Yamaha hi-hat stand models or other brands
- Drummers wanting a performance upgrade rather than a repair
- Anyone unsure which stand model they own
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Fits HS-1200/1200T/1200D
The T and D suffixes are tripod and double-braced variants sharing the same rod.
Detail 03
Pull rod, not a clutch
This is the shaft the clutch rides on. A slipping clutch is a separate part.
Detail 04
Yamaha OEM part
Threading and diameter match factory tolerances, so the clutch and footboard linkage seat without shimming.
Final check
Know before you order
- 01Confirm your stand's model number stamped on the base or tube before ordering
- 02Rod only. Clutch, felts, washers and spring are not included
- 03A bent rod often means a bent lower tube too. Check both
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How do I know if I need the long or short rod?
Pull your existing rod and measure it, or match it against the length Yamaha specifies for your stand. Buying by model number alone can get you the wrong one.
02Will this fit my HS-650 or HS-740?
It is specified for HS-1200, 1200T and 1200D. Other Yamaha hi-hat stands use different rods.
03Does it come with the hi-hat clutch?
No. The clutch is separate and reuses your existing one if it is in good shape.
04Why is my hi-hat not closing fully?
A bent rod is one cause. Also check the spring tension, the clutch position on the rod, and whether the lower tube is straight.
