Detail 01
Controller pedal, not a cymbal pad
It reads your foot position. You still need a hi-hat cymbal pad to strike.

Independent shopping perspective
Yamaha's hi-hat controller pedal for electronic kits — gives you continuous open/closed motion instead of a two-state switch. For drummers building or upgrading a Yamaha e-kit.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
It reads your foot position. You still need a hi-hat cymbal pad to strike.
Detail 02
Half-open and quarter-open sounds become playable, so disco and funk parts sit right.
Detail 03
Built around Yamaha's trigger inputs. Check your module's hi-hat control jack before ordering.
Detail 04
Sits flat on the floor. No stand or clutch to set up, less to carry.
Detail 05
Priced as a serious upgrade part, not a starter accessory. It's a targeted fix for one weakness.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
No. This is the foot controller only. You need a separate hi-hat pad to strike, plus a module that accepts a continuous hi-hat control signal.
It's designed for Yamaha modules. Other brands may read it partially or not at all — check your module's hi-hat input spec before buying.
No. It sends a control signal to an electronic module rather than moving cymbals, so it does nothing on an acoustic setup.
Yes, if your module supports continuous hi-hat data. The pedal reports how far down your foot is rather than just open or closed.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.