Detail 01
Tone and pink-noise outputs: –40, –20, –10 dBu
You can select one of three levels for either test signal.
Product detailSKU #1500000455169
XviveAT-1 Portable Audio Tester
1/15
Independent shopping perspective
The Korena take
Xvive’s AT-1 is a compact audio-test tool for checking equipment and tracing problems away from the bench. Send either a precise 1 kHz tone or pink noise through XLR, 1/4-inch, or 1/8-inch connections at three output levels. It also checks the three pins of an XLR cable, meters XLR inputs, and tests phantom-power voltage. Connect a source and listen through its 1/8-inch jack; the supplied protective belt-clip case keeps the tester ready to travel.
Strong match
Who this is for
- Testing powered speakers, effect pedals, cables, IEM systems, and mixers away from the bench.
- Sending tone or pink noise while troubleshooting audio connections at three selectable output levels.
- Checking XLR cable pins, incoming XLR level, and phantom-power voltage during system diagnosis.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Output impedance: 600 ohm
This is the specified output impedance.
Detail 03
Input impedance: 600 ohm / 3.5 kohm
These are the stated input-impedance values.
Detail 04
Protective case with belt clip
The included case supports carrying the compact tester.
Final check
Know before you order
- 01The input metering is for XLR input signals.
- 02Headphone or speaker monitoring uses the 1/8-inch jack.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Which test signals can the AT-1 generate?
It generates a precise 1 kHz tone or pink noise at –40, –20, or –10 dBu.
02Can it test an XLR cable?
Yes. Its XLR cable test checks whether all three pins are functioning correctly.
03Can it check phantom power?
Yes. It tests the phantom-power voltage output.
04What connectors can it use for test-signal output?
It sends its test signals through XLR, 1/4-inch, and 1/8-inch connectors.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- 1khz Tone Generator 1db
- –40, –20, –10dBu
2 detailsConnections & power
- Input Impedance
- 600 ohm/3.5 kohm
- Output Impedance
- 600 ohm
1 detailsOther
- Pink Noise Generator 1db
- –40, –20, –10dBu
