Detail 01
5 isolated outputs
Each pedal gets its own ground, so no ground loop hum between them. Five is the hard ceiling without doublers.
Product detailSKU #1273887996416
Voodoo LabPedal Power ISO-5 Power Supply
Independent shopping perspective
The Korena take
Five-output isolated pedal power supply with a compact footprint. For small to medium boards that need clean, separated power without an eight-output box.
Strong match
Who this is for
- Boards of four or five pedals needing isolated power
- Fly rigs and small boards where space is tight
- Replacing a daisy chain that's causing hum
Consider the trade-offs
When to look elsewhere
- Large boards — five outputs runs out fast
- Anyone needing 18V for a high-headroom pedal
- Pedals that use anything other than center-negative barrel jacks
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
5.5 x 2.1mm center negative
The standard pedal jack. Center-positive or non-barrel pedals need a separate adapter cable.
Detail 03
4.9 x 3.4 x 1.8 in.
Small enough to mount under most pedalboards. Measure your board's clearance — 1.8 inches of height is the constraint.
Detail 04
IEC power input
Uses a detachable IEC cable, so you can swap in a short one or a right-angle for tight board wiring.
Detail 05
1 lb
Light enough for a gig bag board without adding meaningful weight to a fly rig.
Final check
Know before you order
- 01Add up your pedals' mA draw and match each to an output's rating
- 02Center-positive pedals need a polarity reverse cable, sold separately
- 03Confirm your board has 1.8 inches of under-mount clearance
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How many pedals will it run?
Five directly. Low-draw analog pedals can share an output with a doubler cable, as long as the combined draw stays within that output's rating.
02Will it stop my pedalboard buzz?
If the buzz is ground loop hum from a daisy chain, yes. Each output is isolated with its own ground.
03Does it do 18V?
No. Outputs are the standard center-negative barrel type. For 18V pedals, look at a supply with switchable voltage.
04Can I mount it under my pedalboard?
The 4.9 x 3.4 x 1.8 in. size fits under most boards. Check your clearance and how you plan to attach it.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsConnections & power
- Outputs
- 5.5 x 2.1 mm barrel connectors center negative
- Input
- IEC connector
2 detailsSize & weight
- Dimensions Wxdxh
- 4.9 x 3.4 x 1.8 in. (124 x 86 x 44 mm)
- Weight
- 1
