Detail 01
Nylon
Softer than metal, so it will not chew up mating threads or rattle, but it strips sooner if you overtighten.
Product detailSKU #1274115042001
TAMANylon T Nut 2-Pack
Independent shopping perspective
The Korena take
A two-pack of nylon T-nuts — small threaded inserts for drum hardware. Buy them when a stripped or missing nut is keeping a piece of hardware from tightening.
Strong match
Who this is for
- Replacing a stripped nut so hardware holds position again
- Keeping spares in a hardware bag or gig case
- Repairing older TAMA hardware rather than replacing the whole part
Consider the trade-offs
When to look elsewhere
- Anyone who has not identified which part actually failed
- High-load joints where a metal nut is what came originally
- Players looking for a tone or performance upgrade — this is a repair part
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
T-nut shape
The flange seats against the hardware to stop the nut spinning while you turn the bolt from the other side.
Detail 03
2-pack
Two pieces, so you can do a matched pair or fix one now and keep a spare.
Detail 04
$6.99
Cheap enough to keep on hand. The cost of this repair is your time identifying the right size, not the part.
Final check
Know before you order
- 01Confirm the thread size and seat on your hardware before ordering
- 02No bolts, washers, or tools included — parts only
- 03Hand-tighten; nylon threads strip if you crank on them
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How do I know this is the right size?
Pull the failed nut and compare thread diameter, pitch, and flange size against the replacement. Drum hardware threads vary between brands and even between parts.
02Will these fit non-TAMA hardware?
Only if the thread matches. Treat it as a TAMA part first and verify against your hardware before assuming it crosses over.
03Why nylon instead of metal?
Nylon grips without galling the mating threads and resists loosening from vibration. The trade-off is a lower torque limit — do not overtighten.
04Do I need tools to install them?
Usually just a drum key or a screwdriver to back out the bolt. Nothing is included, so use what the surrounding hardware calls for.
