Detail 01
42 strands
More wire across the head means higher sensitivity and a drier, tighter sound. Roll and ghost-note detail comes through better.

Independent shopping perspective
A 42-strand snare wire for 14-inch snare drums. More strands than a standard 20-strand set, so the response is drier and more sensitive.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
More wire across the head means higher sensitivity and a drier, tighter sound. Roll and ghost-note detail comes through better.
Detail 02
Sized for a 14-inch drum. On a 13-inch or piccolo the wire spread will not sit correctly on the resonant head.
Detail 03
Coiled wire with end plates. Response is quick and articulate rather than loose and buzzy.
Detail 04
High strand counts can choke a deep snare slightly. On a 6.5-inch drum you trade some low-end for detail.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes, if your throw-off and butt plate take standard end plates. Check whether yours uses cord or plastic straps, and have that on hand.
More strands sit across the head, so the drum is more sensitive and drier. Ghost notes read clearly. The backbeat sounds tighter and less open.
Not a 13-inch or smaller one. These are cut for 14-inch drums and will not seat properly on a narrower shell.
Yes. Take off the resonant head to swap the wires, then center them over the snare beds before retensioning.