Detail 01
Ball joint clamp
Tilt and rotate in any direction from one knob, instead of being limited to a fixed angle.
Product detailSKU #1275776905402
Sound Percussion LabsSPH03 Adjustable L-Rod Ball Clamp 10 in.
Independent shopping perspective
The Korena take
A 10 inch L-rod on a ball clamp, for mounting a tom or small percussion off an existing stand or rack at any angle.
Strong match
Who this is for
- Mounting a tom off a cymbal stand instead of the bass drum
- Angling a splash or cowbell exactly where your stick falls
- Rack setups where you need one more mount point
Consider the trade-offs
When to look elsewhere
- Big floor toms — an L-rod and clamp is not the right support
- Stands with no free tube length to grip
- Anyone wanting a locked, repeatable position night after night
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
L-rod geometry
The bend offsets the mounted piece away from the host stand, so it clears the tube it hangs on.
Detail 03
10 inch rod
Enough offset for a small tom or percussion. It won't push a drum far out over the kit.
Detail 04
Clamps to round tubing
Grips a stand upright or rack bar. The host stand carries the full weight, so its base has to be planted.
Final check
Know before you order
- 01No tom, mount bracket or percussion holder is included
- 02Ball joints creep under hard playing — snug the knob, then recheck after a set
- 03Your drum's mount must accept the rod's diameter
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will it hold a rack tom?
It's built for a small tom or percussion off a stand or rack. Larger toms and floor toms belong on legs or a dedicated mount.
02How much can I angle it?
The ball joint tilts and rotates freely in any direction, then locks with one knob.
03Does the tom mount come with it?
No. You supply the drum and whatever bracket your drum's hardware uses to receive the rod.
04Can I put this on a hi-hat stand?
Yes, if there's exposed round tubing to clamp. Adding weight to a hi-hat stand can affect its stability while you're playing it.
