Detail 01
Clamp mount instead of a base
It borrows support from a stand you already own, so one tripod carries two cymbals.
Product detailSKU #1275776905394
Sound Percussion LabsSPC21 Cymbal Arm Clamp 10 in.
1/3
Independent shopping perspective
The Korena take
A 10 inch clamp-mounted cymbal arm that adds a crash or splash to an existing stand or rack, no extra floor stand needed.
Strong match
Who this is for
- Adding a splash or stack without another tripod on a small stage
- Mounting a crash off a rack tube on a large kit
- Filling a gap between existing stands where floor space is gone
Consider the trade-offs
When to look elsewhere
- A heavy 20 inch ride — the short arm gives limited leverage control
- Kits with no spare tube or rack bar to clamp onto
- Players who reposition cymbals constantly during a set
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
10 inch arm length
Short reach. Good for tucking a splash close in, not for pushing a crash far out over the kit.
Detail 03
Attaches to round tubing
Works on conventional stand uprights and rack bars; hex or square tubing will not seat properly.
Final check
Know before you order
- 01No cymbal, felts, sleeve or wingnut assumed — check what your arm needs
- 02Hanging weight off one stand shifts its balance; widen that tripod's legs
- 03Confirm your stand's tube diameter falls in the clamp's range
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What does it clamp to?
Round tubing on a cymbal stand upright, a hi-hat stand or a drum rack bar. Check your tube diameter against the clamp's jaw range first.
02Will it hold a full-size crash?
Yes for a typical crash. Keep heavier rides on their own stand, since all the load transfers to the host stand.
03Does it include felts and a sleeve?
Plan on supplying your own felts, sleeve and wingnut if the arm doesn't arrive dressed.
04Will it fit my rack?
It fits standard round rack tubing. Square or hex rack bars need a clamp made for that profile.
