Detail 01
12 in. length
Short reach. Good for nudging a cymbal a foot off center, not for spanning over a full drum.
Product detailSKU #1275776905383
Sound Percussion LabsSPC16 Pro Cymbal Boom Arm - 12 in.
1/3
Independent shopping perspective
The Korena take
A 12 inch boom arm for cymbal stands and clamps. Adds reach so you can place a cymbal where a straight stand cannot.
Strong match
Who this is for
- Converting a straight cymbal stand into a boom
- Reaching a crash over a rack tom
- Pairing with a multi clamp to add a second cymbal
Consider the trade-offs
When to look elsewhere
- Long reaches across the kit, 12 inches is short
- Hanging a heavy ride far off the stand axis
- Anyone who needs a full stand rather than just an arm
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Boom arm
Sold as the arm alone. You mount it into a stand tube or clamp that already has a receiver.
Detail 03
Short arm, less leverage
Shorter booms put less tipping force on the base than long ones, so the host stand stays steadier.
Detail 04
Pro series entry hardware
Budget tier build. Handles crashes and splashes fine, less suited to constant heavy ride work.
Final check
Know before you order
- 01Check that your stand or clamp accepts this arm's tube diameter.
- 02Cymbal felts, sleeve and wing nut may need to be sourced separately.
- 0312 inches is measured as arm length, actual reach is shorter once angled.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Is this a complete stand?
No. It is the boom arm only. You need a cymbal stand with a boom receiver, or a multi clamp, to mount it.
02How far will a 12 inch boom actually reach?
Less than 12 inches horizontally once you angle it down to playing position. Plan for roughly eight to ten inches of usable offset.
03Will it hold a 20 inch ride?
It will physically hold one, but a heavy ride on a boom loads the host stand's base. Keep the arm short and the base wide.
04Does it fit other brands' stands?
Drum hardware tubing is not fully standardized. Measure the receiver diameter on your stand before ordering.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- 12 in.
