Detail 01
Foam construction
Breaks up wind and breath blasts before they hit the capsule. Slightly softens the very top end.

Independent shopping perspective
Small foam windscreen for Shure mics. Buy it to cut wind noise and plosives, and to keep the grille clean.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Breaks up wind and breath blasts before they hit the capsule. Slightly softens the very top end.
Detail 02
Stretches over the grille, no tools or adapters. Comes off just as fast for cleaning.
Detail 03
Disappears against dark grilles and stage backdrops, and hides dirt better than lighter foam.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It is made for the Shure models the A2WS is specified for. Check your mic's accessory listing to confirm before ordering.
Foam takes a small amount off the extreme top end. In a live mix the wind and plosive reduction is the bigger effect.
Foam windscreens are generally rinsed gently and air dried. Let it dry fully before putting it back on the mic.
This is priced as a single windscreen. Order one per microphone you want covered.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.