Detail 01
Foam construction
Cuts wind and breath blasts, and takes a small amount of top-end brightness with it.

Independent shopping perspective
Foam windscreen for Audio-Technica microphones. Buy it if wind noise or plosives are ruining takes outdoors or on a handheld mic.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Cuts wind and breath blasts, and takes a small amount of top-end brightness with it.
Detail 02
No hardware or stand mount. It stretches over the mic head and stays by friction.
Detail 03
Stays invisible on camera against dark clothing and dark mic bodies.
Detail 04
Sized for a specific set of A-T mic bodies, not a universal one-size cover.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It is sized for particular Audio-Technica bodies. Measure your mic head diameter, or check your mic's manual for the specified windscreen part number, before buying.
Slightly. Foam absorbs a little high frequency energy, so the top end softens a touch. The tradeoff is losing wind rumble and plosive thumps that would otherwise wreck a take.
In a studio, a pop filter on a gooseneck is better — it blocks plosives without touching the capsule or dulling the highs. Use a windscreen when you need something on the mic itself.
Foam windscreens are usually rinsed in warm water with mild soap and air dried completely before going back on the mic. Never put a damp windscreen on a condenser.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.