Detail 01
Matched pair
The two microphones are matched and tested for output and tonal balance in stereo use.
Product detailSKU #1500000462364
RoyerR-12 Active Ribbon Microphone Matched Pair
1/2
Independent shopping perspective
The Korena take
Royer’s R-12 matched pair gives stereo recording setups two active, figure-8 ribbon microphones selected to match in output and tone. Each microphone uses a 2.5-micron aluminum ribbon, active electronics, a switchable -15dB pad, and a 100Hz high-pass filter. The pair is intended for phase-conscious stereo work on piano, drum overheads, acoustic instruments, ensembles, and room capture. Internally shock-mounted ribbon transducers and triple-layer windscreens address handling noise, plosives, and wind, while the supplied stereo case keeps the pair together between sessions.
Strong match
Who this is for
- Stereo tracking piano, drum overheads, acoustic instruments, ensembles, or ambient room sound.
- Stereo setups where matching output and tonal balance across both microphone channels is important.
- Close-miking sources when the 100Hz high-pass filter helps reduce proximity buildup.
Consider the trade-offs
When to look elsewhere
- Recording setups that cannot provide 48V phantom power.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Figure-8 pattern
The microphones provide the specified figure-8 pickup pattern.
Detail 03
Switchable -15dB pad
It is provided for high-SPL sources; maximum SPL is specified at 160dB SPL at 1kHz.
Detail 04
100Hz high-pass filter
It can reduce proximity buildup during close miking.
Detail 05
48V phantom power
Each active microphone requires phantom power.
Final check
Know before you order
- 01Your preamp or interface must supply 48V phantom power.
- 02Use a load impedance of at least 1 kohm.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What comes with the R-12 matched pair?
It includes a stereo case, two mic holders, and two mic socks.
02Are these microphones matched for stereo work?
Yes. Each pair is matched and tested for output and tonal balance.
03What warranty coverage is included?
The original owner receives a 10-year limited microphone warranty and one free re-ribbon within the first year. Registering in the first year extends ribbon coverage to five years.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
3 detailsSound
- Frequency Response
- 30Hz–15kHz ±3dB
- Load Impedance
- 1 kohm minimum
- Sensitivity
- -36dB (re. 1V/Pa)
2 detailsBody & build
- Color
- Natural
- Type
- Active ribbon microphone
3 detailsConnections & power
- Output Impedance
- 200 ohm, balanced
- Connector
- 3-pin XLR (Pin-2 hot)
- Power Requirement
- 48V phantom
3 detailsSize & weight
- Length
- 8-1/4 inch
- Weight
- 16.3
- Diameter
- 1-3/8 inch
12 detailsOther
- Transducer Mounting
- Internally shock-mounted
- Extended Ribbon Coverage
- Free within 5 years (registration required)
- Accessories
- Stereo case, 2 mic holders, 2 mic socks
- Pattern
- Figure-8
- High Pass Filter
- 100Hz, 6dB/octave
- Current Draw
- 4mA
- Microphone Warranty
- 10-year limited (original owner)
- Maximum SPL
- 160dB SPL @ 1kHz
- Pad
- -15dB, switchable
- Ribbon Element
- 2.5-micron aluminum
- Operating Principle
- Electrodynamic pressure gradient with active electronics (matched pair)
- Ribbon Warranty
- First re-ribbon free within 1 year
