Detail 01
14 gauge conductors
Thick enough that a 20-foot run barely wastes amp power, so the cab gets the damping and punch it should.
Product detailSKU #1274034477498
Rapco HorizonSpeaker Cable 14 Gauge 20 ft.
Sale
Independent shopping perspective
The Korena take
A 20-foot 14-gauge speaker cable for running a power amp or amp head to a cabinet. Basic wiring, not a signal or instrument cable.
Strong match
Who this is for
- Amp head to speaker cabinet on stage or in a rack
- Power amp to passive PA tops at small venues
- Spare in the gig bag when a cable fails mid-show
Consider the trade-offs
When to look elsewhere
- Guitar or line-level use — it is unshielded and will hum
- Anyone needing a run past 20 feet from the amp
- Active speakers, which take a signal cable instead
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
20-foot length
Reaches from a side-stage amp rack to a cab across the stage without coiling excess behind the rig.
Detail 03
Speaker cable, not instrument cable
No shield inside, two heavy conductors instead. Never use it between a guitar and an amp.
Detail 04
Black jacket
Disappears against stage floors and cable snakes, so it is not a visual distraction under lights.
Final check
Know before you order
- 01Check your amp and cab jacks — some cabinets use Speakon, not 1/4 inch
- 02Never run a tube amp head without a cab connected through it
- 03Match your amp's minimum impedance when chaining more than one cab
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use this as a guitar cable in a pinch?
No. It has no shielding, so you get hum and noise. Speaker cables carry amplifier power; instrument cables carry a shielded low-level signal.
02Is 14 gauge overkill for 20 feet?
No. Heavier wire keeps resistance low over distance, so more of the amp's power reaches the speaker and the low end stays tight.
03Will this work with my powered speaker?
No. Powered speakers have an amp inside and take a line-level signal cable, usually XLR. This one goes after a power amp.
04How do I tell it apart from my instrument cables?
It is noticeably thicker and stiffer. Label both ends when you buy it so it never ends up in front of an amp input.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
