Detail 01
Desktop height
Sits on a surface, not the floor. Your desk height becomes part of the mic height, so measure both.

Independent shopping perspective
A short boom mic stand meant to sit on a desk or table. For podcasting, streaming, or miking a cab or amp from low down.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Sits on a surface, not the floor. Your desk height becomes part of the mic height, so measure both.
Detail 02
The arm angles the mic out over a desk or into a cab, instead of straight up from the base.
Detail 03
No desk edge required, but it takes up surface area and can be nudged out of position.
Detail 04
Built for home and project use rather than nightly load-in and load-out abuse.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It handles typical desktop mics fine. A heavy condenser in a shock mount, pushed far out on the boom, will strain the base — keep the arm short and centered.
Yes. Desktop height puts it near speaker level on a combo sitting on the floor, and the boom lets you angle across the cone.
No, it stands on the surface. If you need the desk surface clear, look at a clamp-mount arm instead.
No. This is the stand only. Budget separately for the mic, cable, and any shock mount or pop filter.