Korena
Product detailSKU #1315669885772

PearlM8 Wing Nut (2 Pack)

Pearl logo
Pearl M8 Wing Nut (2 Pack)

Independent shopping perspective

The Korena take

Two M8 wing nuts for drum hardware. Replacement or spare fasteners for cymbal stands, tom mounts, and other hardware taking an 8mm thread.

Pearl M8 Wing Nut (2 Pack) product detail
Product studyPearl M8 Wing Nut (2 Pack)

Strong match

Who this is for

  • Replacing a wing nut lost at a gig or in a load-in
  • Keeping spares in a stick bag or hardware case
  • Securing cymbals or accessories on 8mm threaded posts

Consider the trade-offs

When to look elsewhere

  • Hardware using 6mm or imperial threads — the thread will not engage
  • Anyone needing the felts, washers, or sleeves that go with it
  • Players wanting quick-release or locking cymbal toppers

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01

M8 thread

8mm metric thread. Standard on most cymbal tilters and tom arms, but check yours before ordering.

Detail 02

Wing nut

Hand-tightened by the wings. No drum key or tool needed to swap cymbals mid-set.

Detail 03

2 pack

Two nuts. Enough to cover one stand plus a spare, not a full kit's worth.

Detail 04

Pearl hardware

Fits Pearl stands directly and most other brands using the same 8mm thread.

Final check

Know before you order

  1. 01Cymbal felts, sleeves, and washers are not included
  2. 02Verify your stand's thread is M8, not M6, before ordering
  3. 03Two nuts only — a full kit typically needs more

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Will these fit non-Pearl stands?

Usually, if the stand uses an 8mm thread. Many brands share that size, but check the post on your stand first.

02Do I get cymbal felts with these?

No. These are the nuts only. Felts and sleeves are separate.

03How do I know if I need M8 or M6?

M8 is the common size on cymbal tilters and tom arms. M6 shows up on smaller accessory mounts. Compare against a nut you already have.

04Is a tool needed to tighten them?

No. The wings let you tighten and loosen by hand.