Detail 01
Metal body
Thinner walls than rubber leave more room inside for the same outside size, so the sound is brighter and carries further.

Independent shopping perspective
Metal tenor mouthpiece with a mid-range 7 tip opening. For a tenor player replacing a stock piece who wants more projection and edge than hard rubber gives.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Thinner walls than rubber leave more room inside for the same outside size, so the sound is brighter and carries further.
Detail 02
Middle of the range. Enough gap to push volume and bend pitch without the air demand of a wide-open piece.
Detail 03
Bored for a tenor neck. Alto and soprano pieces are not interchangeable, and neither are their ligatures.
Detail 04
Metal mouthpieces are slimmer than rubber ones. A ligature off a rubber piece will sit loose and slip.
Detail 05
Roughly $200 more than the hard rubber version at the same 7 opening. You pay for the material, not a wider tip.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. It is bored and sized for tenor. Alto necks are smaller, and the piece will not seat or seal correctly.
Most players land around medium — a 2.5 or 3 in cane. Coming from a closer tip, drop a half strength and adjust from there.
It projects more and sounds brighter. Raw volume depends on your air, but metal cuts through a mix more easily than rubber.
Only if it was made for a metal tenor mouthpiece. Rubber-piece ligatures are cut wider and will not clamp the reed evenly.