Detail 01
60 lb capacity
Covers most 61- and 76-key synths and controllers. Weigh a heavy stage piano before trusting it up top.
Product detailSKU #1274115029372
On-StageKSA7500 Keyboard X-Stand Add-On 2nd Tier
Sale
1/6
Independent shopping perspective
The Korena take
A second keyboard tier that clamps onto an existing X-stand. For players who already own a stand and want to add a controller or synth above it.
Strong match
Who this is for
- Adding a 61-key controller above a main stage piano
- Putting a drum machine or groovebox within reach while playing
- Freeing desk space by going vertical in a small studio
Consider the trade-offs
When to look elsewhere
- Anyone without a keyboard stand already — this is not standalone
- Heavy 88-key hammer-action boards over 60 lb
- Stands with tubing thicker than 1 inch
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Fits round or square tubing up to 1 inch
Measure your stand's tube before ordering. Thicker legs on some heavy-duty stands won't take the clamps.
Detail 03
16–30 inch width adjustment
The arms slide to match your keyboard's footprint, so narrow controllers and wider 76-key boards both sit stable.
Detail 04
14 inch depth
Deeper keyboards will overhang front or back. Fine for balance, but check that knobs and rear jacks stay clear.
Detail 05
11.5 inch height
Sets the upper tier about a hand's span above the lower one — close enough to reach, high enough to clear your hands.
Detail 06
4.67 lb
Light enough to leave clamped on during transport if your stand folds with it attached.
Final check
Know before you order
- 01Measure your stand's tube diameter and shape first — 1 inch is the ceiling
- 02No keyboard, no base stand, no straps included
- 03Adding weight up high raises the tipping point; keep the base legs wide
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this work with any keyboard stand?
It clamps to round or square tubing up to 1 inch (30 mm) in diameter. That covers most X-stands, but check your tubes before buying.
02How much weight can the second tier hold?
60 lb. That handles typical 61- and 76-key synths and controllers. Heavy 88-key hammer-action boards will exceed it.
03Will my keyboard fit?
The arms adjust from 16 to 30 inches wide and are 14 inches deep. Wider is fine; deeper keyboards will overhang the arms front or back.
04Does it come with a stand?
No. This is an add-on tier only. You need an existing keyboard stand with compatible tubing.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
5 detailsSize & weight
- Weight Capacity
- 60 lb.
- Depth
- 14 inch
- Weight
- 4.67
- Width Adjustment
- 16 inch–30 inch
- Height
- 11.5 inch
1 detailsOther
- Compatibility
- Works with any keyboard stand with round or square tubing up to 1 inch in diameter (30 mm)
