Detail 01
375 lb. weight capacity
Far above any stage piano or mixer. The rating means no sag or flex, not just no collapse.
Product detailSKU #1313854567097
On-StageKS7350 Keyboard Stand
Sale
1/2
Independent shopping perspective
The Korena take
A welded steel stand for a keyboard, mixer or DJ rig. Buy it if you want a support that stays put under heavy gear.
Strong match
Who this is for
- Heavy 88-key stage pianos that flex lighter X-stands
- DJ setups where a controller and mixer sit together
- Gigging players who set up and tear down weekly
Consider the trade-offs
When to look elsewhere
- Players who need the lightest possible stand to carry
- Anyone stacking two keyboards on one frame
- Tight bedroom corners where a 33-inch span won't fit
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
All-welded construction
No bolted joints to work loose or rattle over time, and nothing to assemble out of the box.
Detail 03
1 inch x 2 inch structural tubing
Rectangular tube resists side-to-side sway far better than round tube of the same weight.
Detail 04
21 inch–33 inch telescoping width
Sets how far apart the supports sit. Match it to your keyboard's base, not its total length.
Detail 05
¾ inch center box tubing
The inner sliding tube that carries the width adjustment. Thicker than typical, so the span holds under load.
Detail 06
Black powder coat finish
Baked-on, not painted. Handles scuffs from cases and van floors better than a gloss finish.
Final check
Know before you order
- 01Measure your keyboard's base depth against the 21–33 inch adjustment range first
- 02Welded frame means no assembly, but also no flat-packing into a small case
- 03Cables hang from the keyboard, not the frame — plan a tie-down
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will it hold an 88-key stage piano?
Yes. It's rated to 375 lbs., which is many times the weight of any 88-key board. Just check that your keyboard's base falls inside the 21–33 inch support span.
02How wide does it adjust?
The supports telescope from 21 inches to 33 inches apart.
03Can I put a DJ controller or mixer on it instead?
Yes — it's built for DJ gear, mixers and keyboards. The adjustable span covers gear narrower or wider than a typical keyboard.
04Does it wobble when you play hard?
The frame is welded rather than bolted and uses 1 x 2 inch rectangular tubing, which resists side-to-side sway. The 375 lb. rating means normal playing weight doesn't load it much.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsBody & build
- Color
- Black Powder Coat Finish
- Construction
- All-welded
2 detailsSize & weight
- Weight Capacity
- 375 lbs.
- Telescoping Width Adj
- 21 inch-33 inch
3 detailsOther
- Center Box Tubing
- ¾"
- Structural Tubing
- 1 inch x 2 inch
- Applications
- DJ, Mixer and Keyboards
