Detail 01
TRS (three-conductor) plugs
Carries a balanced mono signal or an unbalanced stereo one, depending on what you plug it into. Confirm your gear before assuming balanced.

Independent shopping perspective
A 6 ft balanced TRS cable from Mogami, built for permanent studio patching between line-level gear where noise and reliability matter more than cost per foot.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Carries a balanced mono signal or an unbalanced stereo one, depending on what you plug it into. Confirm your gear before assuming balanced.
Detail 02
Noise picked up along the run is cancelled at the input, so nearby power and dimmers stay out of the signal.
Detail 03
Rack, desk and patch-bay distance. Too short for anything crossing a room, and slack behind gear disappears fast.
Detail 04
You are paying for consistent shielding and conductor quality across every cable, which matters when you buy a dozen for one rig.
Detail 05
High for a patch cable. It buys longevity and quiet, not a change in tone on short line-level runs.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It will pass signal, but a TRS cable is built for balanced line-level connections. For guitar to amp, use a TS instrument cable instead.
Both, depending on the gear. Into balanced line inputs it carries one balanced mono channel. Into a stereo headphone or aux jack it carries left and right.
You are paying for Mogami's conductor and shielding consistency, which shows up as quiet, repeatable performance across a whole rack rather than in tone.
Only if your console uses a single TRS insert jack that expects a Y-cable. A straight TRS-to-TRS cable will not split send and return.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.