Detail 01
Quad conductor (Neglex Quad)
Four conductors in two pairs instead of two. Cancels magnetic hum pickup far better on long runs near transformers.

Independent shopping perspective
Studio-grade 25-foot quad-conductor XLR cable with Neutrik ends. For anyone tired of buzz on long mic runs near power or lighting gear.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Four conductors in two pairs instead of two. Cancels magnetic hum pickup far better on long runs near transformers.
Detail 02
Industry-standard latch and strain relief. Plugs seat firmly and survive repeated connect cycles without wobble.
Detail 03
Reaches from a stage position to a snake or interface without coiling slack, which is where cables get stepped on.
Detail 04
Noise picked up along the run gets cancelled at the input. This is why long mic runs stay quiet at all.
Detail 05
Disappears on a dark stage. Consider colored tape or heat shrink if you need to identify runs quickly.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes. It's a standard balanced XLR mic cable, so 48V passes through normally to condenser mics.
No. Mic cable is thin-gauge and shielded for low-level signal. Powered speaker runs need speaker cable or speakON.
For hum from magnetic fields — power transformers, dimmers, lighting runs — yes, measurably. For a short quiet run, you likely won't hear a difference.
Yes. Standard 3-pin XLR female to male, so it connects any mic to any mixer, interface, or preamp input.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.