Detail 01
Hard rubber body
Rounder, warmer tone than metal, and it doesn't get cold against your lip in an unheated room.

Independent shopping perspective
Hard rubber alto sax mouthpiece with a medium 6 tip opening. A step up from the piece that comes packed with a student horn.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Rounder, warmer tone than metal, and it doesn't get cold against your lip in an unheated room.
Detail 02
Middle of the range gap between reed and tip. Moderate air needed, flexible for bending notes, not stuffy.
Detail 03
Balanced response. Enough core for concert band, enough edge to be heard over a rhythm section.
Detail 04
Cut for an alto neck. It will not fit soprano or tenor, and reeds must be alto reeds.
Detail 05
The tip rail chips if dropped or knocked against a stand. Cap it every time you put the horn down.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Most alto players land between 2.5 and 3. Softer reeds pair with wider tips, so if you used 3.5 on a stock piece, start at 3.
Yes, it fits a standard alto neck cork. If it goes on too tight, sand the cork lightly; if loose, add cork grease or have the cork replaced.
Different, not better. Rubber gives a warmer, rounder sound and is more common for jazz and concert playing. Metal is brighter and louder, favored for funk and rock horn lines.
Yes, after the first few months. A 6 tip needs steadier air and embouchure than a very close student piece, so it makes more sense once basic tone is stable.