Detail 01
8-ohm version
Most heads produce less power into 8 ohms than 4. The trade is the ability to add a second 8-ohm cab for a 4-ohm total.
Product detailSKU #1274319726216
MarkbassTraveler 102P Rear-Ported Compact 2x10 Bass Speaker Cabinet 8 Ohm
1/5
Independent shopping perspective
The Korena take
A 33-pound 2x10 bass cab at 8 ohms, 400W handling. For players who want one compact cab now with the option to stack a second later.
Strong match
Who this is for
- Bassists who may add a matching cab for bigger rooms
- Club and rehearsal use where a 4x10 is too much box
- Heads with a minimum load of 8 ohms
Consider the trade-offs
When to look elsewhere
- Squeezing every watt out of one cab and one head
- Players wanting the lightest cab available
- Large outdoor stages with no PA support
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Two 10-inch drivers
Quicker attack and more midrange bite than a single 12, with more total cone area pushing air.
Detail 03
101dB sensitivity
Efficient enough that the 8-ohm power loss matters less. A 300W head still gets gig loud.
Detail 04
Rear port
Keep it off the back wall. Boundary loading exaggerates and muddies the low end.
Detail 05
45Hz low end
Low E's fundamental sits just below this. Expect punch and clarity rather than sub weight.
Detail 06
23.4 inches wide, 33 lbs
A one-trip carry, but wider than a 1x12. Measure your car and the stage space you usually get.
Final check
Know before you order
- 01A speaker cable is required. Instrument cable will overheat under power.
- 02Two stacked 8-ohm cabs equal 4 ohms — verify your head is 4-ohm stable.
- 03Confirm what your amp actually delivers into 8 ohms, not just its peak rating.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Should I get the 8 ohm or the 4 ohm?
Take 8 ohms if a second cab is possible later, since two of them make a 4-ohm stack. Take 4 ohms if this will always be your only cabinet.
02Is one of these enough for gigs?
At 101dB sensitivity, one handles rehearsals and most club stages. Loud drummers in large rooms without PA support are where a second cab helps.
03Can I mix this with the 1x12?
Both are 8 ohms, so paired they present 4 ohms. Different driver sizes voice differently, so expect a blended rather than matched sound.
04Does the tweeter make it harsh?
The piezo crosses over at 3.5kHz and adds string and pick detail. If it's too bright for your technique, cut treble at the amp.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
5 detailsSound
- Frequency Response
- 45Hz to 18kHz
- Impedance
- 8 or 4 ohms
- Crossover Frequency
- 3.5kHz
- Sensitivity
- 101dB SPL
- Speaker Size
- 2x10 inch
1 detailsPickups & controls
- Pickup Configuration
- Piezo
2 detailsConnections & power
- Power Handling
- 400W RMS (AES Standard)
- Bass Port
- Rear
2 detailsSize & weight
- Dimensions Wxhxd
- 23.4 inch x 13 inch x 17 inch
- Weight
- 33
1 detailsOther
- Tweeter
- Piezo
