Detail 01
4-ohm version
Your head delivers its maximum power here, but this cab alone is the whole load. Adding a second cab likely drops below your amp's minimum.
Product detailSKU #1274319726212
MarkbassTraveler 102P Rear-Ported Compact 2x10 Bass Speaker Cabinet 4 Ohm
Independent shopping perspective
The Korena take
A 33-pound 2x10 bass cab wired for 4 ohms, 400W handling. For players running a single cab off a head that wants a 4-ohm load.
Strong match
Who this is for
- Getting full rated power from a head into one cabinet
- Club stages needing 10-inch punch in a compact box
- Bassists who want more cone area than a 1x12 without a 4x10
Consider the trade-offs
When to look elsewhere
- Anyone planning to add a second cab later
- Amps that won't run below 8 ohms
- Players prioritizing the lightest possible carry
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Two 10-inch drivers
More total cone area than one 12, with faster attack. Fingerstyle definition and pick articulation cut better through a band.
Detail 03
101dB sensitivity
Slightly louder per watt than most cabs. Combined with 4 ohms, a modest head gets very loud.
Detail 04
Rear port
Give it room to breathe. Against a wall the bass thickens and turns uneven.
Detail 05
45Hz low end
The lowest notes of a 4-string are felt more than heard. A 5-string's B string will sound as harmonics, not fundamental.
Detail 06
23.4 inches wide, 33 lbs
Wider than a 1x12 and eight pounds heavier. Still a one-trip carry, but check your trunk and stage footprint.
Final check
Know before you order
- 01Confirm your amp is 4-ohm stable before buying this version.
- 02This one is 4 ohms; the 8-ohm version is the one to stack.
- 03Bring a proper speaker cable — instrument cable will fail under load.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What's the difference between the 4 ohm and 8 ohm version?
Only the impedance. The 4-ohm draws maximum power from your head as a single cab. The 8-ohm is the one to buy if you may add a second cabinet later.
02Can I run two of these together?
Two 4-ohm cabs in parallel give 2 ohms, which most bass heads cannot drive safely. Buy the 8-ohm version if stacking is the plan.
03Will this handle a 5-string?
It plays a low B, but with response starting at 45Hz the B's fundamental at 31Hz comes through mostly as harmonics rather than deep weight.
04Is a 2x10 louder than a 1x12?
This one is slightly more sensitive and has more cone area, so it generally moves more air. It's also wider and eight pounds heavier.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
5 detailsSound
- Frequency Response
- 45Hz to 18kHz
- Impedance
- 8 or 4 ohms
- Crossover Frequency
- 3.5kHz
- Sensitivity
- 101dB SPL
- Speaker Size
- 2x10 inch
1 detailsPickups & controls
- Pickup Configuration
- Piezo
2 detailsConnections & power
- Power Handling
- 400W RMS (AES Standard)
- Bass Port
- Rear
2 detailsSize & weight
- Dimensions Wxhxd
- 23.4 inch x 13 inch x 17 inch
- Weight
- 33
1 detailsOther
- Tweeter
- Piezo
