Detail 01
Drive with Type 1/Type 2 switch
Lets you select between the two onboard overdrive types before setting drive amount.
Product detailSKU #1500000439635
MarkbassLittle Mark Rocker 58R 300W Bass Amp Head
bluespopfunk rockalternative
1/6
Independent shopping perspective
The Korena take
Built around a 500W-at-4-ohms / 300W-at-8-ohms MPT power section, the Little Mark Rocker 58R is a compact bass head with hands-on control over drive and EQ. Choose either drive type, then use the blend control to bring distorted signal into the clean sound. Its four-band EQ and Old/Cut/FSW selector make fast tonal changes practical from the front panel. A level-controlled balanced D.I. output, pre/post-EQ selection, and mute switch cover direct-to-PA routing and silent changes.
Strong match
Who this is for
- Live bass setups needing a level-controlled balanced D.I. feed and pre- or post-EQ selection.
- Changing between clean and distorted bass sounds with the drive type, drive, and blend controls.
- Using Old or Cut EQ settings for quick front-panel tone changes during a set.
Consider the trade-offs
When to look elsewhere
- Players who need foot control of Drive and the Cut EQ preset without buying the optional dual footswitch.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Blend: Clean to Distorted
Controls the balance between clean and distorted signal.
Detail 03
Four-band EQ: 68Hz, 360Hz, 800Hz, and 10kHz; ±16dB
Provides separate low, low-mid, mid-high, and high adjustment.
Detail 04
Balanced D.I. out with level control
Provides a balanced direct output with its own output-level adjustment.
Detail 05
10.87 × 10.08 × 3.27 inches; weight 4.4
A compact head format for transport between setups.
Final check
Know before you order
- 01The dual footswitch for Drive and Cut EQ preset control is optional and sold separately.
- 02Power is rated at 500W into 4 ohms and 300W into 8 ohms.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I blend clean bass with distortion?
Yes. The blend control runs from clean at the counter-clockwise end to distorted at the clockwise end.
02What does the three-way switch do?
It selects Old, Cut, or FSW. The FSW position is used with the optional footswitch for the Cut EQ preset.
03Can I send the amp to a PA?
Yes. It has a balanced D.I. output with level control and pre/post-EQ switching.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- Power
- 500W @ 4 ohm/300W @ 8 ohm
1 detailsPickups & controls
- 3 Way Switch
- Old/Cut/FSW
1 detailsBody & build
- Type
- MPT
4 detailsSize & weight
- Weight
- 4.4
- Depth
- 10.08 inch/25.6 cm
- Width
- 10.87 inch/27.6 cm
- Height
- 3.27 inch/8.3 cm
9 detailsOther
- Blend
- Clean (counter-clockwise)/Distorted (clockwise)
- Mid High
- Center frequency 800Hz; level ±16dB
- Fsw
- Optional dual footswitch for Drive and Cut EQ preset (sold separately)
- High
- Center frequency 10kHz; level ±16dB
- Low
- Center frequency 68Hz; level ±16dB
- Send Return
- Pre/Post EQ – GND switches
- Low Mid
- Center frequency 360Hz; level ±16dB
- Drive
- With Type 1/Type 2 switch
- Balanced D I Out
- With level control
