MackieHR824mk2 8.75" Powered Studio Monitor (Each)
Product overview
About this model
The high-resolution Mackie HR824mk2 8.75" powered studio monitor sounds as smooth as it looks. The rounded contours of the HR824mk2 monitor's Zero Edge Baffle minimize diffraction to give you a crystal clear audio image of your mix. The Mackie Optimized Waveguide delivers full, articulate mids, while the rear-firing, mass-loaded passive radiator ensures tight bass extension to 37Hz. Acoustic Space, low-frequency (LF) roll-off and high-frequency (HF) controls let you easily tailor the sound to suit your space and taste. And thanks to remarkably linear frequency response, Mackie HR824mk2 audio monitors ensure accurate mix translation. Combine all this with wide, even dispersion and Mackie HR824mk2 monitors turn your studio's sweet spot into a full-on sweet zone.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
9 detailsSound
- Free Field Frequency Response
- &plsumn;1.5dB, 37Hz to 20kHz
- Upper Cutoff Frequency
- -3dB @ 22kHz
- Sensitivity 2 83v 1m
- 91dB SPL
- High Frequency Driver
- Sensitivity (2.83V, 1m): 91dB SPL
- Rated Load Impedance
- 6 ohms
- Lower Cutoff Frequency
- -3dB @ 35Hz
- Frequency Range
- 1.6kHz to 22kHz
- Nominal Impedance
- 6 ohm
- Low Frequency Filter
- -3dB @ 37Hz, 2nd-order transitional high-pass filter, -3dB @ 47Hz, 4th-order Chebyshev high-pass filter, -3dB @ 80Hz, 4th-order Butterworth high-pass filter
1 detailsBody & build
- Color
- Red
11 detailsConnections & power
- Power Handling Long Term Program
- 20W/50W
- Input Protection
- Rfi and Level Protected
- Input Type
- Balanced Differential (XLR and 1/4 inch TRS), Unbalanced (RCA)
- Maximum Input Level
- +20dBu
- Low Line Voltage Shut Down
- 60% of Nominal Line
- Rated Power For Ul 6500 Csa E65 94 En 60065
- 150W
- Sound Pressure Level At 1 Meter 7 5dbu Into Balanced Input
- 100dB SPL @ 1m
- Burst Power Output
- 210W
- Input Impedance
- 20 kohm Balanced, 10 kohm Unbalanced
- Rated Power At 1khz with 1 Thd
- 100W
- Rated Thd 1w to 1db of Rated Power
- 0.1 %
10 detailsSize & weight
- Diameter
- 8.75 inch (170 mm)
- Height
- 16.8 inch/42.5 cm
- Weight
- 34.6
- Depth Overall
- 13.8 inch/35.1c m
- Voice Coil Diameter
- 1.0 inch (25.4 mm)
- Residual Noise Maximum Gain 600 Source 20hz 20khz Bandwidth
- < 8dB SPL @ 1m
- Signal to Noise 20hz 20khz Unweighted Referenced to 40w Into 8 Ohm
- > 102dB
- 20hz 20khz Unweighted Referenced to 150w Into 4 Ohm
- > 102dB
- Depth Enclosure
- 11.4 inch/29 cm
- Width
- 10.8 inch/27.3 cm
1 detailsIn the box
- Standby Mode
- 8W
23 detailsOther
- Hf Equalization
- ±2dB @ 10kHz, shelving
- Bucking Magnet
- Ferrite opposing magnet
- Driver Protection
- Independent LF and HF Detection, Overall Compression
- Us
- 120 VAC, 60Hz
- Crossover Type
- Modified Linkwitz-Riley, 24dB/octave @ 1,900Hz
- Maximum Peak SPL per Pair
- 120dB SPL @ 1m
- Muting
- 5 seconds at turn-on
- Distortion Thd Smpte Imd Dim 100
- < 0.035%
- Cooling
- Convection
- Diaphragm Suspension
- Titanium with polymer suspension
- Frame
- Die-cast magnesium
- Acoustic Space
- (A position) -4dB @ 50Hz, shelving, (B position) -2dB @ 50Hz, shelving, (C position) flat
- Maximum Short Term SPL On Axis Half Space 80hz to 2 5khz
- 111dB SPL @ 1m
- Musical Program Loud Mix
- 135W
- Slew Rate
- 35V/S
- Over Excursion Prevention
- 2nd Order High-Pass filter
- Quiescent Idle
- 18W
- Passive Radiator
- 6 inch x 9 inch (152 mm x 228 mm) mass-loaded elliptical flat
- Design
- Monolithic IC, Conventional Class AB
- Thermal Protection
- Amplifier Shut-Down, Auto Reset
- Enclosure Alignment
- 6th Order
- Magnet
- Neodymium
- Fully Shielded
- Ferrite opposing magnet
