Detail 01
Latching action
One press turns it on and it stays there. Press again to release. Opposite of momentary, which only holds while pressed.
Product detailSKU #1275860129176
LivewireLWS21 Universal Latching Footswitch
Independent shopping perspective
The Korena take
A $24.99 latching footswitch from Livewire. For switching an amp channel or effect on and stays on until you press it again.
Strong match
Who this is for
- Switching amp channels where the state must hold between presses
- Replacing a lost or broken footswitch on an older amp
- A cheap spare to keep in the gig bag
Consider the trade-offs
When to look elsewhere
- Amps that expect a momentary switch — latching will behave wrong
- Players needing multiple functions from one pedal board switch
- Anyone wanting LED indication of which state is active
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Universal
Built to fit common footswitch jacks rather than one brand. Compatibility still depends on what your amp expects.
Detail 03
Single switch
Controls one function. Channel switching plus reverb on the same amp needs a two-button unit.
Detail 04
$24.99
Priced well under most factory replacement switches, which is usually the reason to buy one.
Detail 05
Passive footswitch
No battery or power. It opens and closes a connection your amp is already reading.
Final check
Know before you order
- 01Check your amp's manual — it must call for latching, not momentary
- 02Confirm the jack type your amp uses before ordering
- 03Some amps invert the state, so on may read as off
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What is the difference between latching and momentary?
Latching holds its state after you lift your foot. Momentary is only active while you press down. Amps are wired for one or the other, and swapping them gives backwards behavior.
02Will this work with my amp?
It is built as a universal switch, but your amp has to be looking for a latching switch on a matching jack. Check the manual before ordering.
03Can it switch two things at once?
No. This is a single switch for one function. Channel plus reverb means a dual footswitch instead.
04Does it need power or batteries?
No. A footswitch like this just makes or breaks a connection the amp is already reading, so there is nothing to power.
