Detail 01
Neck-through-body construction with graphite reinforcement
The three-piece maple neck runs through the body and is reinforced with graphite for stability and sustain.

Independent shopping perspective
Built in Jackson’s Corona, California factory, the American Series Rhoads RR24 HT pairs an alder Rhoads body with a neck-through, graphite-reinforced three-piece maple neck. Its 12–16-inch compound-radius ebony board carries 24 jumbo stainless-steel frets, supporting lower-register chording and higher-fret bends. A Seymour Duncan JB bridge humbucker and ’59 neck humbucker feed master volume and tone controls through a three-position blade switch. The fixed Hipshot hardtail bridge, Graph Tech TUSQ XL nut and Gotoh locking tuners form its hardware setup.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
The three-piece maple neck runs through the body and is reinforced with graphite for stability and sustain.
Detail 02
Its radius changes from a more curved lower register to a flatter upper register for chording and bends.
Detail 03
The bridge and neck pickups are selected with a three-position blade switch.
Detail 04
There are 24 jumbo frets on the ebony fingerboard.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
A Seymour Duncan JB TB-4 humbucker at the bridge and a Seymour Duncan ’59 SH-1N humbucker at the neck.
No. It uses a fixed Hipshot hardtail bridge.
24 jumbo stainless-steel frets.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.