Detail 01
1/4" TRS male on one end
Plugs into the gear. The headphone side is the 3.5mm female, so this extends outward from the amp or interface.

Independent shopping perspective
A 25 ft extension that takes a 3.5mm headphone plug and lands it in a 1/4" TRS jack. For monitoring away from the desk.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Plugs into the gear. The headphone side is the 3.5mm female, so this extends outward from the amp or interface.
Detail 02
Accepts consumer headphone plugs directly. No extra adapter needed for earbuds or portable cans.
Detail 03
Carries left, right and ground, so stereo stays intact over the full run.
Detail 04
Long enough to reach a vocal booth or the far side of a live room without a second cable.
Detail 05
Disappears on a dark stage floor, but harder to spot when you are coiling up in low light.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Not directly. The far end is a 3.5mm female socket, so a 1/4" headphone plug will not fit without a separate adapter.
Yes. The TRS wiring carries left and right channels plus ground.
It is built as a headphone extension. The 3.5mm female end means you would need another cable or adapter to reach a standard input.
Only if you do not need the distance. Coil the slack rather than leaving it loose on the floor.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.