Detail 01
Upper rod
The section running through the upper tube to the clutch. Lower shafts and footboard linkages are separate parts.
Product detailSKU #1273887992832
GibraltarStandard Hi-Hat Stand Upper Rod
Independent shopping perspective
The Korena take
Replacement upper pull rod for a hi-hat stand. For drummers repairing a bent or stripped rod rather than replacing the whole stand.
Strong match
Who this is for
- Fixing a hi-hat that sticks or wobbles from a bent rod
- Keeping a spare in the hardware case for gigs
- Reviving an older Gibraltar Standard stand cheaply
Consider the trade-offs
When to look elsewhere
- Anyone without a hi-hat stand already — this is a part
- Drummers unsure which rod their stand takes
- Stands from other makers with different rod threading
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Gibraltar Standard line
Cut for Gibraltar's Standard-series hi-hat stands. Fit on other lines or brands is not a given.
Detail 03
Threaded top end
The clutch screws onto this. Damaged threads are the usual reason a rod gets replaced.
Detail 04
$9.29
Cheap enough to buy before you need it. A dead rod otherwise sidelines the whole stand.
Final check
Know before you order
- 01No clutch, cymbals, felts or washers included — rod only
- 02Measure your old rod's length and thread before ordering
- 03You will need to pull the upper tube to swap it
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this come with the hi-hat clutch?
No. This is the rod alone. Your existing clutch threads onto it.
02Will it fit my non-Gibraltar hi-hat stand?
It is made for Gibraltar Standard stands. Rod length and thread pitch vary between brands, so check your old rod against the spec before buying.
03Why would I need to replace the upper rod?
Bent rods bind in the tube and make the hi-hat sluggish or notchy. Stripped top threads stop the clutch from holding.
04Is this hard to install?
It is a straightforward swap: loosen the upper tube, slide the old rod out, drop the new one in, reattach the clutch.
