Detail 01
Rubber
Absorbs contact between metal and cymbal bell, cutting rattle and protecting the cymbal edge around the center hole.

Independent shopping perspective
Replacement rubber seat that sits on a hi-hat pull rod and cushions the top cymbal. Buy it when the original has torn or gone missing.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Absorbs contact between metal and cymbal bell, cutting rattle and protecting the cymbal edge around the center hole.
Detail 02
Sits under the top cymbal on the pull rod, so it wears faster than any other part of the stand.
Detail 03
Sized for Gibraltar pull rods; fit on other brands depends on rod diameter, which varies.
Detail 04
Cheap enough to buy several at once, which is worth doing since these tear without warning.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It cushions the top cymbal where it rides on the pull rod, keeping metal off metal so the cymbal seats cleanly and does not rattle or wear at the hole.
It is a Gibraltar part sized to Gibraltar rods. Other brands often use similar dimensions, but measure your rod before ordering.
At this price, two or three. They are small, easy to lose during teardown, and split with age.
No. This is the rubber seat only. Clutches, felts and wing nuts are sold separately.