Detail 01
Short length
Sits low on the threaded rod. Good for a single cymbal; a taller stack may need the long version to stay covered.
Product detailSKU #1273887992970
GibraltarRubber Cymbal Sleeve - Short
1/2
Independent shopping perspective
The Korena take
Short rubber sleeve for a cymbal stand tilter. A consumable part — replace it when the old one splits and metal starts touching your cymbal.
Strong match
Who this is for
- Replacing a cracked or missing sleeve on a crash or ride stand
- Protecting the bell hole on a new or expensive cymbal
- Stocking a few spares in the stick bag for gigs
Consider the trade-offs
When to look elsewhere
- Stands needing a long sleeve to clear thick washers or stackers
- Hi-hat clutches, which use their own felts and hardware
- Anyone wanting a full stand upgrade — this is one small part
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Rubber, not plastic
Rubber grips the rod and flexes with the cymbal's swing instead of cracking at the base like hard plastic does.
Detail 03
Covers the threaded rod
Stops sharp stand threads from wearing the cymbal's bell hole, which is what causes keyholing over time.
Detail 04
$4.49
Cheap enough to replace on schedule rather than waiting for it to split mid-set.
Final check
Know before you order
- 01Check whether your stand needs the short or long sleeve before ordering
- 02Felt washers are not included — those are a separate part
- 03One sleeve covers one cymbal position; count your stands
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What is the difference between short and long sleeves?
Length of rod covered. Short suits a single cymbal on a standard tilter. Long is for taller setups where washers, stackers or thick felts leave more rod exposed.
02Will this fit a non-Gibraltar stand?
Cymbal stand rods are broadly standardized, so it fits most common stands. Compare against your current sleeve if you run older or unusual hardware.
03How many do I get?
Treat this as one sleeve for one cymbal position. If you are refreshing a full kit, order one per stand, plus a spare for the bag.
04How often should I replace a cymbal sleeve?
When it splits, thins out, or lets the cymbal touch metal. Check them whenever you change heads — a worn sleeve is what wears the cymbal's hole.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Short
