Detail 01
Block-style rubber
Flat contact patch spreads weight over more floor area than a round tip, so less sliding and denting.
Product detailSKU #1273887992871
GibraltarBlock Rubber Feet
Independent shopping perspective
The Korena take
Rubber replacement feet for Gibraltar hardware. Buy these when a stand's original feet are worn, missing, or sliding on hard floors.
Strong match
Who this is for
- Replacing cracked or lost feet on existing Gibraltar stands
- Stopping stand creep on tile, hardwood, or riser surfaces
- Keeping hardware from scratching finished floors at home
Consider the trade-offs
When to look elsewhere
- Players needing feet for non-Gibraltar hardware without checking leg diameter
- Anyone wanting spurs or spikes that bite into carpet
- Fixing a wobbly stand caused by a worn tilter or loose joint
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Rubber, not felt or metal
Grips hard floors and absorbs some vibration. On thick carpet it still sits on top rather than digging in.
Detail 03
Gibraltar hardware fitment
Sized to Gibraltar leg tubing. Other brands vary in diameter, so measure your leg end before ordering.
Detail 04
Consumable part
Rubber hardens and tears with gigging. Treat these as a wear item you replace, not a one-time upgrade.
Final check
Know before you order
- 01Measure your stand leg diameter — fitment is by tube size, not brand alone
- 02Check how many feet come in the pack before assuming a full set
- 03Old feet can seize on; twist rather than pry to avoid bending the leg
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will these fit my hi-hat stand?
They fit Gibraltar-sized leg tubing. Pull one existing foot and measure the tube's outside diameter, then compare before ordering.
02Do these stop the stand from sliding?
On hard floors, yes — rubber grips tile and hardwood much better than bare metal or worn tips. On carpet, use a rug with a backing instead.
03Can I use these on a cymbal stand and a snare stand?
Yes, as long as the leg tubing matches. Foot type is not specific to the stand's job, only to the leg it slides onto.
04How do I get the old ones off?
Twist while pulling rather than levering with a screwdriver. Prying can bend or gouge the leg end the new foot needs to seat on.
