Detail 01
Tilt-back floor-monitor design
It can be positioned in front of the player or placed behind in the conventional amplifier location.
Product detailSKU #1500000239921
FriedmanASM-10 500W 1x10 Bi-Amp Powered Guitar Monitor
1/8
Independent shopping perspective
The Korena take
Designed for guitar modelers and profilers, the ASM-10 combines a 10-inch, two-way active cabinet with 500W of analog bi-amped power. Its tilt-back floor-monitor layout can sit in front of you and direct sound toward you, or it can occupy a standard amplifier position behind you. Rear-panel level, low-cut, and ground-lift controls let you balance volume and frequencies in the setup. A balanced 1/4-inch input and balanced XLR link output handle its listed connections.
Strong match
Who this is for
- Modeler or profiler performances where a tilted cabinet sits in front and directs sound toward the player.
- Stage rigs that may place the monitor in front or behind, depending on the required location.
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Bi-amped power output
The LF section is specified at 270 Wrms Class G, while the HF section is specified at 80 Wrms Class AB+B.
Final check
Know before you order
- 01Configured as a 10-inch two-way active stage monitor for modelers and profilers.
- 02Its listed dimensions are 20.5 inches H x 15.25 inches W x 13.25 inches D.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can the ASM-10 be placed in front of the player?
Yes. Its tilt-back design is intended to sit comfortably in front of you and direct sound toward your ears.
02Can it also sit behind me like an amplifier?
Yes. The cabinet can be placed behind you in a traditional amplifier position.
03What connections are specified?
A balanced 1/4-inch input and a balanced male XLR link output.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsPickups & controls
- Low Cut Filer (switchable)
- 3rd order Butterworth @ 100Hz
- Pickup Configuration
- 10” 2-Way Active Stage Monitor for use with modelers/profilers
2 detailsConnections & power
- Maximum total burst power
- 500W
- (1/8 power pink noise)
- 150VA
26 detailsOther
- Frequency Range
- 50Hz - 20kHz
- Configuration
- 10” 2-Way Active Stage Monitor for use with modelers/profilers
- High Frequency Transducer
- Celestion PETP film compression driver with 1” voice coil
- Amplifier Protection
- Short circuit, Clip-limiter, Overheat mute, SOA output stage, Driver DC protection, Subsonic filter, Turn-on mute and soft ramp, Turn-on inrush current limiting
- Enclosure
- Black Texture painted, Baltic birch plywood construction
- Input Sensitivity **
- 775mV (0dBu)
- Tier
- new
- Low Frequency Transducer
- Celestion - 10” TF1025E woofer
- Controls
- Level knob , Low-cut filter switch, Ground lift switch
- Hardware
- Strap handle, Rubber feet / Rubber Strips
- Frequency Response
- 58Hz -18kHz
- Indicators
- Power, Protect
- Assembly
- Made in USA using premium worldwide components
- Category Source
- detail
- Cooling
- Convection
- Maximum peak SPL
- 129dB
- Korena Special
- false
- Dimensions (WxHxD)
- 15.25" (38.74 cm) x 20.5" (52.07 cm) x 13.25" (33.66 cm)
- Weight
- 40.9 lbs (18.55 kg)
- Power Output
- LF: 270Wrms Class G / HF: 80Wrms Class AB+B
- Connectors
- Balanced 1/4” input / Balanced male XLR link output
- Input Impedance
- 20k Ohm Balanced / 10k Ohm Unbalanced
- High Frequency Dispersion
- Optical Wave Guide
- Power Consumption @
- 1.7A/0.85A 115Vac/230Vac
- Electronic Crossover
- 4th order
- Source Id
- site51500000239921
Worth comparing
1 of 12
More from Friedman
1 of 8
