Detail 01
R3 nut
Sized for a 1-11/16" nut width. Match this to your neck; an undersized nut misaligns the outer strings.

Independent shopping perspective
Nickel-finish double-locking tremolo with an R3 locking nut. Direct replacement for guitars already routed and drilled for a Floyd.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Sized for a 1-11/16" nut width. Match this to your neck; an undersized nut misaligns the outer strings.
Detail 02
Warmer, slightly grayer than chrome. Sits close enough to chrome hardware to pass, and dulls with hand contact over time.
Detail 03
Lowest-cost Floyd tier. Same dimensions and double-locking function as pricier versions, with less durable metals under heavy use.
Detail 04
Strings are clamped at both ends. Bends and dive-bombs return to pitch, but every tuning change becomes a bench job.
Detail 05
Rear cavity springs must be set against string tension. Change string gauge and you re-balance the whole bridge.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. Nickel is slightly warmer and less mirror-bright, and it dulls with handling. Next to chrome hardware the difference is visible but subtle.
Not without work. The stud spacing and rout depth of a Floyd differ from a vintage or two-point trem, and the locking nut needs its own shelf.
Slow. You unclamp the nut, retune at the headstock, rebalance the floating bridge, then re-clamp and fine-tune. Not something to do mid-set.
Yes, within a small range. Once the nut is clamped, the fine tuners at the bridge are how you correct pitch without unlocking anything.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.