Detail 01
American Standard fitment
These bridges take a push-in arm held by a collet or tension screw, not a threaded one.

Independent shopping perspective
Replacement tremolo arm for American Standard and later two-point Strat bridges. For a missing, bent, or rattling arm.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
These bridges take a push-in arm held by a collet or tension screw, not a threaded one.
Detail 02
The arm drops in and swings freely. Height and tension are set at the bridge, not by turning the arm.
Detail 03
No collet, tension screw, or tip. If the receiver in the block is worn, the new arm still rattles.
Detail 04
Shaft size is matched to Fender's US two-point block, so other bridges may hold it loosely or not at all.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Push-in. American Standard bridges use a straight shaft held by tension in the block. Vintage Strats use the threaded version instead.
Depends on the bridge. Players Series and other two-point models are usually compatible; six-screw vintage-style bridges are not.
The tension screw or collet in the bridge block has likely worn. Adjust or replace that before assuming the arm is the problem.
Plan on reusing your old tip. If it is cracked or lost, source one separately.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.