Detail 01
Batter head
Goes on the top, stick side. It does not replace the thin bottom head that sits over the wires.
Product detailSKU #1274034479361
EvansHybrid Marching Snare Drum Batter Head Gray 14 in.
1/6
Independent shopping perspective
The Korena take
A 14-inch batter head built for marching snare tension. Made for corps and drumline players who need a head that holds pitch under high tension outdoors.
Strong match
Who this is for
- Marching band or drum corps snare, played outdoors
- Players tensioning a snare well past kit-drum range
- Replacing a worn batter head on a 14-inch marching snare
Consider the trade-offs
When to look elsewhere
- Drum kit snares — this is tuned much higher than kit heads
- Anyone needing a resonant, open-sounding head for recording
- Snare-side use — this is the top head only
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Marching-specific build
Designed to survive extreme tension without denting or losing pitch across a long outdoor rehearsal.
Detail 03
14 in.
Head size must match the drum's shell diameter exactly, not the hoop or the rim measurement.
Detail 04
Gray coating
The textured surface adds stick grip and takes some edge off the attack compared to clear film.
Detail 05
Hybrid weave construction
Layered material trades some sensitivity for durability and articulation, so rudiments stay clean at volume.
Final check
Know before you order
- 01Measure the shell diameter, not the rim — 14 in. heads will not fit 13 in. drums
- 02One head only. No snare-side head, wires, or tuning key included
- 03Marching tension needs a drum key and even lug-by-lug seating to avoid warping
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use this on a regular drum kit snare?
You can, but it is built for marching tension. On a kit tuned lower it will sound choked and stiff compared to a standard batter head.
02Do I need a new snare-side head too?
Not required, but bottom heads wear faster than tops. If yours has been on a while, replacing both at once gives a more even response.
03Will this fit a 14-inch piccolo or standard snare?
Yes. Head size is set by shell diameter, not shell depth, so any 14 in. snare works regardless of how deep it is.
04Is this the top or bottom head?
Top. It is the batter head, the one you strike. The snare-side head is a separate, much thinner head.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Gray
