Detail 01
Coated surface
The textured layer takes brushes and warms the attack slightly compared to a clear head of the same build.
Product detailSKU #1274034479709
EvansG1 Coated Batter Drum Head 14 in.
Independent shopping perspective
The Korena take
A coated 14-inch Evans batter head. Inexpensive, standard fit, and the usual choice for a rack tom or a snare batter.
Strong match
Who this is for
- Re-heading a 14-inch tom or snare that has lost its tone
- Players who want brush work on a coated surface
- Stocking spares before a run of gigs
Consider the trade-offs
When to look elsewhere
- Drums other than 14 inch — sizing is exact
- Players wanting maximum stick attack and brightness
- Anyone needing a resonant-side head
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
G1 single-ply
One layer of film. More open and resonant than a two-ply head, but it dents and wears faster.
Detail 03
Batter head
This is the side you strike. The bottom resonant head is a separate, thinner part.
Detail 04
14 in.
The most common size on a kit — fits both a standard snare and a 14-inch floor or rack tom.
Detail 05
Around $25
Cheap enough to change often, which matters because single-ply heads lose tone before they break.
Final check
Know before you order
- 01Needs a drum key to seat and tune — not included
- 02Single head only, no resonant head in the box
- 03Retune after an hour of playing as the head settles
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use this on a snare?
Yes, on a 14-inch snare as the batter head. The coated surface is the standard choice for snare work.
02Coated or clear — what's the difference?
Coated has a textured layer that takes brushes and softens attack a little. Clear is brighter with more stick definition.
03How long will it last?
Single-ply heads dent and lose pitch faster than two-ply. Hard hitters may change them every few months; light players get much longer.
04Do I need any tools?
A drum key, which is not included. Loosen the tension rods, lift the hoop, swap the head, then tension gradually in a star pattern.
