Detail 01
Coated Mylar
The coating adds a little surface texture and takes some ring off the attack, softening the beater click.

Independent shopping perspective
A 20-inch coated bass drum batter head with adjustable damping, for drummers who want to dial in muffling at the head instead of stuffing the drum.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
The coating adds a little surface texture and takes some ring off the attack, softening the beater click.
Detail 02
Head size must match the drum's shell diameter, not the hoop or the old head's printed name.
Detail 03
You set attack and sustain at the head rather than adding blankets, so the drum stays tunable.
Detail 04
This is the beater side only. The front head facing the audience is a separate purchase.
Detail 05
Low-end weight over high-end snap. Cutting attack through a loud stage will lean on your beater and mic.
Detail 06
Built to take repeated beater strikes at one spot, which is where bass heads normally wear through first.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. This is cut for a 20-inch shell. A 22-inch drum needs a 22-inch head; the diameter has to match exactly.
No. This is the batter side, the one your pedal beater strikes. The resonant front head is sold separately.
Usually not. The damping is adjustable at the head itself, which is the point of this design. Add internal muffling only if you want an extremely dead sound.
Coated adds surface texture that trims a bit of overtone and brightness, giving a slightly warmer, less ringy attack than a clear head of the same build.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.