Korena
Product detailSKU #1274034479605

EvansEC Resonant Tom Head 6 in.

Evans
Evans EC Resonant Tom Head 6 in.
1/5

Independent shopping perspective

The Korena take

Six-inch bottom head for a small rack tom. Replacement part for drummers with a 6-inch tom who want more controlled sustain.

Evans EC Resonant Tom Head 6 in. product detail
Product studyEvans EC Resonant Tom Head 6 in.
Evans EC Resonant Tom Head 6 in. alternate view
Alternate view

Strong match

Who this is for

  • Rebuilding a small rack tom that rings too long
  • Matching resonant heads across a full tom setup
  • Replacing a bottom head dented from a rimshot or stick drop

Consider the trade-offs

When to look elsewhere

  • Anyone needing a batter head — this is the bottom head
  • Drums other than 6-inch toms; the size does not stretch

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Evans EC Resonant Tom Head 6 in. construction detail

Detail 01

Resonant head

The bottom head. You don't strike it. It sets sustain length and how much the drum opens up after the hit.

Detail 02

EC construction

Edge control — damping built into the head instead of tape or rings. Trims overtones without killing the fundamental.

Detail 03

6 inch

Very small tom, very high pitch and short decay already. The head's damping tightens that further.

Detail 04

Bottom vs batter thickness

Resonant heads run thinner than batters. Don't over-tension trying to match your top head's feel.

Final check

Know before you order

  1. 01Head only — no hoop, tension rods, or batter head included
  2. 02A 6-inch tom needs both heads replaced to hear a full change
  3. 03Measure the shell's bearing edge diameter, not the rim, before buying
Evans EC Resonant Tom Head 6 in. close-up

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Can I use this as a batter head?

No. It's built as a resonant head — thinner and not made to be struck. Use a batter head on top.

02How should I tune the bottom head relative to the top?

Same pitch as the top for even sustain, slightly higher for pitch bend down, slightly lower for a fatter tone. Start matched.

03Will this reduce ring on my tom?

Yes. The edge control damping shortens sustain and cuts high overtones compared to a plain single-ply resonant head.

04Does a 6-inch tom even need a resonant head?

If your drum has bottom hoops and rods, yes — running it without one changes the tone and leaves the shell open.