Detail 01
12 in. length
Short run. Fits roughly one or two clamps depending on clamp width, not a full kit span.
Product detailSKU #1316478174933
DW12 in. Straight Rack Bar
Independent shopping perspective
The Korena take
A 12-inch straight rack bar for DW rack systems. Short section for filling a gap or adding one more mounting point.
Strong match
Who this is for
- Adding a short span for one extra cymbal arm
- Bridging a gap between two existing rack sections
- Extending a rack sideways without a full-length bar
Consider the trade-offs
When to look elsewhere
- Anyone starting from scratch with no rack legs or clamps
- Players needing a long span across the front of the kit
- Kits built on other brands' rack tubing
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Straight, not curved
Runs in one line. Wrapping around the player takes curved bars or angled joints instead.
Detail 03
Bar only
Mounting to your kit still requires clamps at each connection point, bought separately.
Detail 04
DW rack tubing
Diameter matches DW clamps. Mixing brands can leave clamps loose or non-seating.
Final check
Know before you order
- 01No clamps or legs included — this is the tube alone
- 02Confirm your clamps match DW tube diameter before ordering
- 03Measure the gap first; 12 inches fills less than most players expect
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this come with clamps?
No. The bar ships on its own. Every connection to a leg, another bar, or a cymbal arm needs a clamp.
02Can I cut this shorter?
It can be trimmed, but the cut end will be open and needs a cap to finish it.
03Is 12 inches enough for a full rack side?
No. It is a short section meant to extend or bridge. A side span across a kit needs a considerably longer bar.
04Will DW clamps from an older rack fit this?
If they were made for DW rack tubing, yes. Clamp fit depends on tube diameter, so check an existing clamp against the bar.
