Detail 01
1.5 in. tube size
Sized for standard 1.5 in. rack tubing. Measure your bar before ordering; smaller-diameter racks will not seat.
Product detailSKU #1316478172523
DW1.5 in. to V Angle Stacker Rack Clamp
1/6
Independent shopping perspective
The Korena take
A stacker clamp that adds a second tier to an existing DW rack, holding a new bar at an angle off a 1.5 in. tube.
Strong match
Who this is for
- Adding a second rack tier above an existing bar
- Angling a side wing off a straight front rack
- Hanging extra cymbals without adding floor stands
Consider the trade-offs
When to look elsewhere
- Drummers without an existing rack system to clamp onto
- Racks built on tubing other than 1.5 in.
- Anyone needing to mount a tom or cymbal arm directly
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Stacker design
Clamps onto a bar you already own and receives a second bar, so it builds vertically rather than mounting gear.
Detail 03
V-to-angle geometry
The receiving side pivots, so the second bar can run off at an angle instead of parallel to the first.
Detail 04
Bar-to-bar clamp, not a gear mount
Nothing hangs directly off it. You still need memory clamps or arms on the bar it holds.
Detail 05
DW rack hardware
Built around DW rack dimensions. Third-party racks may work if tubing matches, but fit is not guaranteed.
Final check
Know before you order
- 01No rack bar included. This connects bars you already own or buy separately.
- 02You will need cymbal arms or tom mounts for anything hung off the new bar.
- 03Check tubing diameter and available clear space on the existing bar first.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this come with a rack bar?
No. It is a clamp only. It joins a second bar to a bar you already have, and both bars are purchased separately.
02Will it fit my rack?
It is built for 1.5 in. tubing. If your rack uses that diameter it should seat; other diameters will not.
03Can I mount a cymbal arm straight into it?
No. It receives a rack bar, not an arm. Mount arms on the bar it holds using separate memory or gear clamps.
04Can the angle be adjusted after setup?
Yes. The V-to-angle joint loosens so you can reposition the second bar, then retighten to hold the new position.
