Detail 01
800W per channel at 4 ohms
Two 4-ohm cabinets get full power. At 8 ohms it drops to 400W each, so match the cabs.
Product detailSKU #1275776902496
BehringerEUROPOWER PMP1680S 10-Channel 1,600W Powered Mixer
Sale
1/4
Independent shopping perspective
The Korena take
10-channel powered mixer with 800W per side, built for small bands and mobile PA work who want mixer and amp in one box.
Strong match
Who this is for
- Bar and coffeehouse gigs where one box beats a rack
- Small mobile DJ or karaoke rigs needing mains plus monitors
- Church or meeting rooms running a few mics and playback
Consider the trade-offs
When to look elsewhere
- Studios needing a mixer to feed studio monitors, not speakers
- Bands already owning powered speakers with built-in amps
- Anyone who needs more than 10 channels or wants scalable racks
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Bridged mode, 1200W RMS at 8 ohms
Combines both amps into one output. Use it only when you need a single big mains feed, not mains plus monitors.
Detail 03
Twist-lock speaker connectors
Locking connectors won't pull out mid-set. Bring cables with that plug, not bare wire or 1/4 inch.
Detail 04
3-band EQ at 80Hz, 2.5kHz and 12kHz, ±15dB
Fixed frequency points. Broad tone shaping only; you can't sweep in on a specific feedback ring.
Detail 05
+30dB gain with a 10dB pad
Enough for quiet dynamic mics, and the pad keeps hot line sources from clipping the input.
Detail 06
1,050W power consumption, 120V
Draws real current at full tilt. On a shared circuit with lights, expect breaker trouble.
Final check
Know before you order
- 01Speakers, speaker cables and mics are separate purchases
- 02Confirm your cabinets are 4 to 8 ohms before wiring both channels
- 039.9 lbs, but no rack ears or road case included
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I run mains and monitors at the same time?
Yes. One amp channel feeds the mains, the other feeds a monitor mix, each into 4 to 8 ohm cabinets.
02Does it have effects?
There is a digital effects section with a delay of up to 5 seconds, run through 24-bit converters.
03Will this power passive PA speakers?
Yes, that's the point. It is for passive cabinets. Powered speakers with their own amps do not need it.
04How loud will this get?
800W per side at 4 ohms is enough for small clubs and rooms of a hundred or so people with efficient cabinets.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
3 detailsSound
- Impedance Approx
- 10 kohm
- Impedance
- approx. 1 kohm
- Frequency Response
- < 10Hz–200kHz (-1dB), < 10Hz-> 200kHz (-3dB)
1 detailsPickups & controls
- Bridge
- 8–16 ohm
3 detailsBody & build
- Color
- Red
- Type
- Twist-lock professional speaker connector
- RMS 1 Thd Bridged Mode
- 8 ohm 1200W
5 detailsConnections & power
- Max Output Level
- +21dBu
- Mains Connector
- IEC standard receptacle
- Power Consumption
- 1,050W
- Max Input Level
- +21dBu
- Peak Power Bridged Mode
- 8 ohm 1600W
2 detailsSize & weight
- Dimensions Hxwxd
- 12-2/5 inch x 18-1/10 inch x 8-3/5 inch, 315 mm x 460 mm x 220 mm
- Weight
- 9.9
20 detailsOther
- Usa Canada
- 120V, 60Hz
- Converter
- 24-bit Delta-Sigma, 64/128-times oversampling
- Signal to Noise Ratio
- 110dB / 114dB A-weighted (0dBu In @ +10dB gain)
- Mid
- 2.5kHz / ±15dB
- Main Mono Main Mono
- 4–8 ohm
- Gain
- +30dB, +10dB with pad
- High
- 12kHz / ±15dB
- Monitor Main Mono
- 4–8 ohm
- Low
- 80Hz / ±15dB
- 8 Ohm per Channel
- 400W
- Dynamic
- s D/A 90dB
- Main L R
- 4–8 ohm
- Delay Time
- max. 5 secs
- Noise Thd N
- 0.001% / 0.0007% A-weighted
- Sampling Rate
- 40kHz
- 4 Ohm per Channel
- 800W
- Fuse 100
- –120V T 10 A H 250V
- Fuse 220
- –240V T 6.3 A H 250V
- Mic E I N 20hz 20khz
- @0 ohm source resistance -112dB / 114dB A-weighted, @50 ohm source resistance -112dB / 114dB A-weighted, @150 ohm source resistance -112dB / 114dB A-weighted
- Signal Run Time Line in Gt Line Out
- approx. 1.5ms
