Detail 01
24-inch size
Fits a 24-inch bass drum only. Head size matches drum diameter, not the hoop or rim measurement.

Independent shopping perspective
A 24-inch two-ply bass drum batter head with a built-in felt muffle ring. For drummers wanting controlled low end without stuffing pillows inside the kick.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Fits a 24-inch bass drum only. Head size matches drum diameter, not the hoop or rim measurement.
Detail 02
Two plies with a floating muffle ring at the edge. Kills overtones while leaving the center free to move.
Detail 03
This is the side the pedal beats on. It does not replace the front resonant head with the port hole.
Detail 04
More durable than single-ply under a hard beater, and naturally shorter sustain with more low-mid thud.
Detail 05
Uses a molded hoop system, so seating in the drum tends to be consistent without much coaxing.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Usually not. The built-in muffle ring handles most of the ring. Some players add a small amount of internal damping for a completely dead studio sound, but many run it bare.
Batter. It goes on the side your pedal strikes. The front head with the port hole is a separate resonant head.
No. Drum heads are diameter-specific. A 24-inch head only fits a 24-inch drum.
Both are muffled kick heads in the same family. The III uses a different ply and muffling configuration for more damping. Compare by how dry you want the kick.