Detail 01
Piccolo-specific sizing
Cut for a piccolo headjoint bore, which is much narrower than a flute's. A flute cork will not fit.
Product detailSKU #1274319727390
Allied Music SupplyPiccolo Head Cork
Independent shopping perspective
The Korena take
Replacement stopper cork for a piccolo headjoint. A cheap consumable for anyone whose piccolo has gone flat, breathy or hard to tune.
Strong match
Who this is for
- A piccolo that has lost pitch stability or response over years
- Techs keeping a common consumable on the bench
- Owners of an older instrument whose original cork has shrunk
Consider the trade-offs
When to look elsewhere
- Flutes — the head cork diameter is different
- Players unwilling to sand and position the cork themselves
- Anyone chasing tone changes rather than fixing a leak
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Natural cork stopper
It compresses to seal the tube end. When it dries and shrinks, air escapes and the octaves stop lining up.
Detail 03
Cork position sets tuning
Where the cork sits inside the head determines octave alignment. Fitting it is a tuning job, not just a swap.
Detail 04
Fitted, not drop-in
Expect to sand the diameter down for a snug press fit; too tight splits nothing but too loose leaks.
Detail 05
Cost
Low enough to keep a spare, and cheap next to sending a headjoint out for service.
Final check
Know before you order
- 01Needs sanding to fit — no tools or adhesive included
- 02You reuse the existing crown and stopper assembly
- 03Set depth with the mark on your piccolo cleaning rod, then check octaves
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How do I know my piccolo cork needs replacing?
Octaves drift out of tune, response feels stuffy, or the cork moves when you turn the crown. A shrunken cork no longer seals the tube.
02Will a flute head cork work on a piccolo?
No. The piccolo bore is much smaller, so a flute cork will not enter the headjoint. Use the piccolo size.
03How do I set the cork position?
Use the line scribed on the piccolo cleaning rod — center it in the embouchure hole, then confirm octaves against a tuner.
04Can I replace it myself?
Yes, if you can sand cork to a press fit and set depth accurately. If octaves stay off after fitting, hand it to a tech.
