Detail 01
6 inch rail-to-rail depth
Only shallow gear fits between the rails. Measure your amps and power conditioners before ordering.
Product detailSKU #1274115027324
SKBRoto Rack Console - Audio and DJ Rack Case 10 X 4
1/23
Independent shopping perspective
The Korena take
A 14-space rack case with a slanted 10-space top and 4-space bottom, built for mixers and DJ or live setups run standing up.
Strong match
Who this is for
- Mobile DJs racking a mixer above a power amp
- Live sound techs who need angled access to controls
- Studio corner rigs where the mixer sits at eye level
Consider the trade-offs
When to look elsewhere
- Anyone needing more than 6 inches of rear clearance
- Players hauling deep power amps or long rackmount servers
- Anyone wanting a slim single-space case for one unit
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
19-1/2 inch front rail to back lid
The lid adds most of the usable depth. Cables and rear connectors live in that space, not the rails.
Detail 03
10 top / 4 bottom rack spaces
The top section angles toward you for mixers and controls. The bottom stays vertical for amps and processors.
Detail 04
24 lb empty
Loaded with a mixer and amp this becomes a two-hand carry. Plan for stairs and load-in.
Detail 05
23-1/2 inch exterior width
Wider than the 19 inch rack standard. Check your vehicle and shelf clearance.
Detail 06
Roto-molded shell
Thick plastic shell absorbs impact better than plywood cases and shrugs off weather on outdoor gigs.
Final check
Know before you order
- 01No rack screws, washers or shelves included with the case itself
- 02Measure gear depth first; 6 inches rail-to-rail rules out many power amps
- 03The angled top section changes how gear reads. Plan your layout before mounting
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How many total rack spaces is this?
Fourteen: ten in the angled top section and four in the vertical bottom section.
02Will a rackmount power amp fit?
Only a shallow one. You have 6 inches rail to rail, which excludes most full-depth power amps.
03Does it have wheels?
No wheels. At 24 pounds empty plus your gear, plan on lifting it or using a cart.
04Is the top really angled?
Yes. The 10-space top section is set at a console angle so mixer controls face you when the case is standing.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsBody & build
- Color
- Audio and DJ Rack Case 10 X 4
- Rack Space Units Top
- 10
7 detailsSize & weight
- Rack Depth Rail to Rail
- 6 inch
- Rack Depth Front Rail to Back Lid
- 19-1/2 inch
- Exterior Depth
- 17-3/4 inch
- Exterior Length
- 23-1/4 inch
- Product Weight
- 24 lb.
- Weight
- 24
- Exterior Width
- 23-1/2 inch
1 detailsOther
- Rack Space Units Bottom
- 4
